AVCR problems

Mooser

Mooser

Member
Having a few issues with plumbing my avcr in am I right in thinking the map sensor T pieces into the vac line coming off the FPR and then the apexi solenoid goes in the place of the standard solenoid? And you do away with the standard boost solenoid?

Also after wiring it in and plugging the display in nothing happens? Do the sensors need to be plugged in to get power to the screen?

Mickie
 
Mooser

Mooser

Member
rich1216 said:
£220 + postage if you want it
Click to expand...
Il get back to you mate lost the rag last night and put it 12v straight to the unit and it powered up so tested the voltage coming from the ecu and it's only 1.21v so clearly got an issue so where il have another look on Saturday and get back to you :/

Mickie
 
Mooser

Mooser

Member
johnny gtir said:
You soldering wires onto harness ?
Click to expand...
Yeah all soldered apart from the purple as I will be changing it after mapping had a bit deeper look into it last night it seems to be an earth problem all wires are fine and I get 12v from the ignition feed and the unit powers up if I directly earth the unit going to wait till it's all up and running again on Saturday and go from there.

Mickie
 
S

Sye

New Member
both of your grounds need to be on same wire 1cm apart, if this is loose or not ground properly the display wont work, buttons will light but no display, my map sensor was T-pieced into the rubber pipe going to the dump valve
 
Mooser

Mooser

Member
Sye said:
both of your grounds need to be on same wire 1cm apart, if this is loose or not ground properly the display wont work, buttons will light but no display, my map sensor was T-pieced into the rubber pipe going to the dump valve
Click to expand...
Yeah Iv got them soldered in 1-2cm apart still nothing only works if I put a jumper cable over straight to earth and yeah map sensor only reads manifold pressure so it doesn't matter which one it goes to as I say il get stuck into it on Saturday hopefully can sort somthing out


Mickie
 
Mooser

Mooser

Member
well I got it all working and have put the settings in but the rpm on the unit is really high and jumps about when im sitting still between 3000 and 7000 no idea whats going on any one got any ideas?

Thanks

Mickie
 
Mooser

Mooser

Member
Well...... Finally got everything working on the electronics side now that it's all working and plumbed in I can't get anything over 0.62bar of boost got all the settings in for running a bar but the boost doesn't increase it's the same as if it's running in the off position really starting to get peeved with this can anyone help?

thanks

Mickie
 
You must log in or register to reply here.
Top