BabyGodzillaGTi-R
Member
Hey i'm curious if anyone have used Brian Crower or Kelford cams before in the forum?
Apparently BC makes cams for our cars when i emailed them considering u don't see them in their catalogue.
Also does anyone know off hand if normal SR20 springs and retainers fit on our cars or we need to order GTi-R specific ones?
Normally which spring and retainer kits wold u go for? I did a forum search people tend to avoid the Tomei because they are good for 11.8mm while the Tomei cams normally exceed 12mm of lift.
Also for most people when they install cams were there any specific brands where shimming wasn't necessary or it is something one must be ready to prepare for?
If shimming is a route u cannot take how do u guys go about it? Would u grind the valve seat at the expense of loosing compression?
On a side note does anyone know if BC makes GTi-R specific rods?
Apparently BC makes cams for our cars when i emailed them considering u don't see them in their catalogue.
Also does anyone know off hand if normal SR20 springs and retainers fit on our cars or we need to order GTi-R specific ones?
Normally which spring and retainer kits wold u go for? I did a forum search people tend to avoid the Tomei because they are good for 11.8mm while the Tomei cams normally exceed 12mm of lift.
Also for most people when they install cams were there any specific brands where shimming wasn't necessary or it is something one must be ready to prepare for?
If shimming is a route u cannot take how do u guys go about it? Would u grind the valve seat at the expense of loosing compression?
On a side note does anyone know if BC makes GTi-R specific rods?