rossdj1983
New Member
jus wondered what the best way to run the wires from the engine bay to the dash? cant really see any thin to obvious
hks evc
- Thread starter rossdj1983
- Start date
Fire & skill
Vintage member
what evc is it?
the older ones would fit in the centre console if you dont mind doing a wee bit work. as for getting the wiring harness in, take off the drivers front wheel and remove the splash gaitor - you will be able to see a large rubber grommet that can also be accessed just above the pedals on the drivers floor. put the seat as far back as it goes, if you get a torch you can see it, its a bit awkward and means lying on the footwell and looking up behind the dash. TBH once you find the grommet and poke a hole through it should only take you 2mins to feed the cable in.
the older ones would fit in the centre console if you dont mind doing a wee bit work. as for getting the wiring harness in, take off the drivers front wheel and remove the splash gaitor - you will be able to see a large rubber grommet that can also be accessed just above the pedals on the drivers floor. put the seat as far back as it goes, if you get a torch you can see it, its a bit awkward and means lying on the footwell and looking up behind the dash. TBH once you find the grommet and poke a hole through it should only take you 2mins to feed the cable in.
rossdj1983
New Member
jus had a look, looks good, but is there any thin on the other side of the car, im gonna relocate the battery to the boot
Fire & skill
Vintage member
im not sure mate! its always a job ive managed to get out of doing, even after fitting front mounts. i just moved the battery tray forward. PM thundergod, he is a believer in relocating the battery