I'm Lost Help :S

S

SIR GTIR

Member
Hey everyone
finally got round to putting all my new gear in
GT3071R
Sard 800cc injectors
Z32 AFM
PLMS daughter board
turbo smart FPR

well i got the turbo on and got the car started after that tho i had a slight vac leak from the breather hose that runs to the intake

so then i started putting the Afm injectors and Ecu in after that it's Not going

I've got spark
had a Plug out seemed that they were wet (May recheck)

it's fired once or twice but then only cranks over done a diag 55 so thats all good to any ideas People ?
 
M

MarkTurbo

Well-Known Member
Is the ecu actually mapped for the Z32 & 800's or did you just chuck them in and hope it would run :lol:
 
S

samgtr

Member
you have to get it mapped to run those injectors and z32 you have fouled the plugs , you will need to torch the plugs to clean them, then get it set up.

Sam
 
S

SIR GTIR

Member
Ya i've done all that
been mapped by a good tuner thats tuned a good number of R's
Alienprobe well known in N.z forums
mate came over with his consult cable
It's now throwing 2 codes 11 and 21
crank angle sensor
and
ignition circuit

Seems now that theres no spark so i'll have to see weather i can borrow a coil off a mate

as for the cam angle sensor Don't know as the engine was running fine before the turbo swap
 
Last edited:
S

SIR GTIR

Member
Well it's running again
ended up being the ecu i used

after a little help from a Mate of mine we swapped the daughter board over and after having fun trying to get the ecu to reset and start without bringing up the code 11
 
You must log in or register to reply here.
Top