L
Lista
Guest
About 18mm of the end of the key is in the barrel, even if i put rest of key in, it wont turn, the key aint magnetic, so cant go down the road...
Attempted using super glue on end of remaining key and pulling it out that way, but its so slim and sharp, cant get it to stick... cant get nothing in the ignition to get it out like paperclips etc...
Only two other ideas i have is putting some resin on end of key, letting it dry and pulling it out like that, or putting some single strand insulated copper wire into the ignition to touch the end of the key, put an electric charge through the wire, and get a slight spark, enough to 'braise' it onto end of broken key to pull it out... other than that, i aint a clue...
Any ideaS?
(By the way, yes this is the 1st post ive made here, but i will introduce my self etc, just later, ie, i aint using u lot for this)... :roll:
Attempted using super glue on end of remaining key and pulling it out that way, but its so slim and sharp, cant get it to stick... cant get nothing in the ignition to get it out like paperclips etc...
Only two other ideas i have is putting some resin on end of key, letting it dry and pulling it out like that, or putting some single strand insulated copper wire into the ignition to touch the end of the key, put an electric charge through the wire, and get a slight spark, enough to 'braise' it onto end of broken key to pull it out... other than that, i aint a clue...
Any ideaS?
(By the way, yes this is the 1st post ive made here, but i will introduce my self etc, just later, ie, i aint using u lot for this)... :roll: