Needed-greddy profec b settings for 1 bar and 1.1 or 1.2bar

[Anonymous]

hi, just trying to set up my greddy profec b boost controller on the road this evening
if anyone
has their settings for low boost 1.bar
high boost 1.1 or 1.2bar
that would be great

for 1 bar

gain=
set=1.00
warning=1.20
limiter=

for 1.1 bar

gain=
set=1.1
warning=1.20
limiter=

 

[Anonymous]

From what i can recall from this piece of paper i just found i used to run the following on my R

off standard boost at standard factory setting 0.70 i think

on
low boost set at 0.90bar

set 38%
gain 15
set 0.90
warning 1.20
limiter l.30

high boost set at 1.2bar

set 50%
gain 25
set 1.10
warning 1.30
limiter l.40

Hope this helps....

 

[Anonymous]

cheers allover iam not sure its doing it mate
i set high boost to 1 bar as a test and only got peak boost of 0.89? Maybe the gain setting is too low, does anyone else have their settings?, iam sure a few of you have the greddy profec b spec 2 boost controller, pm if you like
cheers Andrew

 

[Edd]

I recently set up my mates (richpulsar) greddy profec b

once you get used to it it's a piece of piss.

Now i only used the gain and set gain functions

put them both at 0%

now i forgot which one, but just keep upping one about 35% was 1 bar and 38% 1.1 bar you might get some nasty spiking, so then you need to up the other gain setting to get rid of the spiking.

sounds complicated but best thing to do is someone drive the car while the other sets it up, took us about 15 mins to set up 10psi and 16 psi and the car flies with barely any spiking and solid boost over the rev range 8)

 

[Anonymous]

thanks edd, i will try and pm richpulsar to ask him to jot down his settings and pm them to me, if not could you give him a call and ask him to jot them down and send them to me, if not then richpulsar if your about help me out lol