Clutch Fork?

[Sailor96]

Hello my fellow legends

Driving the other day and it was nearly impossible to get into gear. Clutch pedal suddenly got soft with a slight click towards the end of the pedal range.

Checked the fluid reservoir, it was still full. Checked that the slave cylinder is moving it's full travel length. The fork itself seems to be firmly in place, not tons of play.

I'm thinking the clutch Fork pivot ball either snapped or push through the fork itself, since I've read a few posts of it happening on this forum.

Thoughts or suggestions?

 

[Smo]

As you said, could be the fork itself - this happened to my previous Pulsar;

It's a bastard but there are options out there to make sure it never happens again.

Could also be the clutch pedal box where it attaches to the bulkhead. I've seen failures there with stiffer clutches.

 

[Sailor96]

Thanks @Smo forgot about that, I do have the support bracket installed but I will double check the pedal support didn't break.
I do have a billet clutch fork from alien speed parts waiting around for the spare motor I've been working on in the background. I can use that for the current gearbox. Ordered some mt90, fork retaining spring and a new clutch throw out bearing just in case.
I'll have to review taking the box off in the car or get my hands on a hoist

 

[Sailor96]

Removed the boot over the slave cylinder this morning. Checked out the clutch fork with a borescope



A semi confusing photo, top left is the silverish pressure plate and you can see the throw out bearing mated to it. Bottom right is the clutch fork. As you can probably tell the clutch fork has infact split right on the ball pivot. This is causing the pedal to feel light or loose as it hasn't broken off completely yet. Just enough to not allow gear changes.

I'm glad I went ahead and ordered parks. The clutch fork I already have but the mt90 and throw out bearing are already here. Waiting on a new retaining spring

In the meantime taking the mounts off to see if I can attempt removing the gearbox with the engine in place