Standard turbo
- Thread starter DavidGTi
- Start date
vss irvine
Well-Known Member
?????
stumo
Active Member
yeah, the roller bearing goes all the way round!!!!!:roll::roll::roll:
P
pulsarboby
Guest
180 roller bearings the one to have as it cuts the loading by half of the 360 roller bearing unit
eastwood
New Member
OK ill get the drimmel out and cut in half :lol:
P
pulsarboby
Guest
hacksaw would be better as it takes more thrust to operate although there would be significant back and forth movement (which may lead to leaky oil seal).
where as the dremmel would give similar performance to the 360 roller unit during cutting in procedure!
actually the dremmel would work best if mounted in the housing with the impellor attached as it has a very high rotational force.
where as the dremmel would give similar performance to the 360 roller unit during cutting in procedure!
actually the dremmel would work best if mounted in the housing with the impellor attached as it has a very high rotational force.
eastwood
New Member
Is that like one of thosse electronic turbos you can buy on ebay..............
P
pulsarboby
Guest
yep but the dremmel version would be much more efficient. im gonna build one tomorrow now and see what cfm it will pump out:lol::lol:
eastwood
New Member
Post up the results and how to may have a go myself just wondering wether to use the flexi shaft with wire brush bit or a flap wheel because I dont think there will be much turbine effect from a cutting disc:lol: