pulsar kid
New Member
Iam stripping my block down ready for honeing,
and was woundering how do i remove the dip stick pipe??
and was woundering how do i remove the dip stick pipe??
oil dip stick pipe,
- Thread starter pulsar kid
- Start date
Dangerous Dave
Active Member
Get a flat headed screw driver and a hammer and knock it out mate;-)
pulsar kid
New Member
Thankyou, job for tonight.
vss irvine
Well-Known Member
is a hammer and screwdriver the only thing yorkshire men have in their toolbox?
if you get a set of molegrips on the flat part of the tube down at the block, then you should be able just to twist it out
if you get a set of molegrips on the flat part of the tube down at the block, then you should be able just to twist it out
vss irvine
Well-Known Member
while doing the shake and vac......
pulsar kid
New Member
lol ill try that 1st. also do i need a pully removal tool to take the crank pully off as this and the crank and oil pump is the last things to remove before i can get it honed,
Dangerous Dave
Active Member
Yes it is, and its the fastest way to do this job:-D no point pulling your arm or anything!:roll::lol:
No get a rubber mallet and abit of wood then just knock it off
It is easyier if you get the correct tool for the job tho;-)
Last edited:
darkyGTI-R
New Member
olliecast
Active Member
darkyGTI-R
New Member
Fook me now you're showing your age Ollie lol
there are two small threaded holes on the pulley, 10mm i think, just screw some long bolts into them - once they start to tighten - do each side up a bit of a time and it will push it off.