Any heard of?

STU666V

STU666V

Active Member
Mmmmm.

On a other search.....

Here is a guy call Bip78 (http://www.stdrivers.co.uk/forum/topic/ ... ustom-map/) who is running a Turbo Technics hybrid (MD999- larger compressor, uprated shaft and turbine wheel with cut back blades) circa £1300, with all supporting mods (everything except injectors), which has pushed the bhp up the rpm range a bit and is finally running 211bhp (180whp) @ 3900 (after getting a few custom maps from different companies).
 
S

Stewm6204

Member
Haha that dont sound too promising ill have a search about too nite im only after 300bhp so if it goes pop at that its nae use haha
 
STU666V

STU666V

Active Member
warpspeed said:
That'll no be 800-1100hp then Stu?....lol
Click to expand...
10-4 scott... thats a no :)

I just seen this. Was on a ford site so explains it.....

MD? So a standard Garrett turbo sold by Turbo Dynamics with one of their badges on then?The american RX7 thats in Issue11 of Jtuner (not out yet) runs one (just not from TD), its a GT42, and yes, the compressor housing is .66 a/r.Not the usual GT42 compressor housing, same as Rods dont use the usual GT40 comp housing you see.Here it is again...ReplyAnonymous*04:24 PM 21-02-2006The previous owner informs me that its a GT42R turbo that turbo dynamics supply.So yes steve, that all makes sense.Too big for me probably, unless i build the M3-Turbo ive always hankered after*You dont know anyone after one do you per chance? I can do you a good deal on commision for selling it*ReplyYBP*04:41 PM 21-02-2006So between 800 and 1100hp somewhere then. There are several gt42 specs.And you probably need two yb´s to get it spinning..**
 
W

webadmin

Guest
As above, its Turbo Dymanics equivalent of a GT42 turbo, 800 - 1100bhp.

Very big for our cars for sure.
 
S

Stewm6204

Member
Cool cheers well if ill be thinking about more power next year mibby looking for 400-450 as thinking of doing a full restoration body wise after iv seen Scott's work the other day and gets the mind working lol
 
S

Stewm6204

Member
Would that mean it takes longer too spool because of its size? Or a bad side affect along those lines when its going i need to smash ma bro's scooby sti lol
 
S

Stewm6204

Member
Ill try getting some the morn scott warpspeed should have it apart then to do the crank seal but its defo not that big im just going from what the papework says form when i had it changes as i blew 2weeks after me having it defo a roller bearing by the sounds of it when you switch it off
 
You must log in or register to reply here.
Top